SAN ANTONIO, TX · METRO 2.6M
GM AFM / DOD / DFM Disable Programming in San Antonio
Ship from anywhere in the San Antonio metro — south Texas's largest metro. We complete the work within 24 hours of receipt and ship back at the return speed you choose at checkout — standard to overnight.
$250 flat 24-hour bench ~1-day USPS from TX
What you get
- AFM / Displacement On Demand disabled in the ECM calibration when supported
- ECM programmed so the engine stays in V8 mode (system present but disabled)
- Bench read + verify of your calibration before any changes
- Calibration written back on the bench with a stable, regulated power supply
- Bench communication tested before the module ships back
- ECM returned with tracking — return-shipping speed your choice at checkout
- Programming since 2012, by an experienced module programmer
San Antonio FAQ
Common questions from customers shipping from San Antonio.
How long does shipping take from San Antonio to Arlington TX?
USPS Priority Mail from San Antonio typically arrives in 1 business day at our Arlington workshop. UPS Ground similar. Same-day work starts when your module hits our bench.
How much does it cost to ship from San Antonio?
USPS Priority flat-rate from San Antonio to Arlington runs about $9. Customer pays shipping to us; return shipping is selected at checkout — $14.95 standard (3-5 business days), $29.95 UPS 2-Day, or $74.95 UPS Next Day Air, flat nationwide.
Do you accept modules from San Antonio?
Yes — we ship to/from all 50 US states. San Antonio is one of our active metros given south Texas's largest metro.
Is there a shop in San Antonio that does gm afm / dod / dfm disable programming?
Most local shops in San Antonio don't have the bench equipment for this kind of work — they'd send the module to a specialty workshop like ours regardless.
Can AFM / DOD be disabled by programming only?
On many supported GM Gen 4 V8 ECMs, AFM / DOD can be disabled in the calibration. This keeps the system present but disabled so the engine stays in V8 mode. Support depends on the ECM, operating system, and calibration, which we verify before accepting the order.
Can this be done on the bench?
Yes. We program supported GM ECMs on the bench using a proper bench harness and a stable, regulated power supply, then test communication before the module ships back.
Do I need to remove the engine heads?
Not for a software disable only. Removing the heads is normally part of a mechanical AFM delete or a lifter replacement job, not the programming step.
Full details
GM AFM / DOD / DFM Disable Programming service page
Compatibility, what it fixes, shipping instructions, warranty.
Same service from other metros:
Ship from San Antonio today
Pay now, get the Arlington shipping address by email, drop it in the mail. Full round-trip from San Antonio: ~5-7 days.